6.
CONTROL STATION
For the AR2 gear motors equipped with control station proceed as follows.
6.1
Connect phase L1 to terminal n. 4.
6.2
Position the switch AUTO/MAN on manual position shown by hand picture
6.3
Switch on / switch off as follows:
6.3.1
By positioning the switch on the symbol: ▲ (open) the square shaft rotates
counter clockwise ↺ and the motor opens (cam S2 adjusts end position "open");
6.3.2
By positioning the switch on the symbol: ▼ (closed) the square shaft rotates
clockwise ↻ and the motor closes (cam S1 adjusts end position "closed").
6.3.3
By positioning the switch in the middle the motor does not run.
Picture n. 4
7 of 8