Advertisement
3.
INSTALLATION
3.1
The AR2 gear motor must be positioned so that the square shaft (POWER END)
is turned towards the device to be put in motion.
3.2
If no other adjustment of the rotation angle is expressly requested, the AR2 gear
motor is always supplied from the factory with standard adjustment of
endswitches for a 90° rotation.
3.3
The square shaft on the POWER END side is positioned in the factory as shown in
picture n. 1
3.4
Viewing the POWER END side square shaft rotates:
- clockwise ↻ (closes) feeding the terminals
- counter clockwise ↺ (opens) feeding the terminals
3.5
The AR2 gear motor must be free to be stopped by its electric endswitches; the
installation of mechanical locks or the presence of other retainers can damage it.
Picture n. 1
n. 1 – 2
n. 1 – 3
3 of 8
Hide quick links:
Advertisement
