Advertisement
Safety precautions
BEWARE:
The use of this device is allowed only with fault current protection switch with a triggering nominal
current up to 30mA (according to VDE 0100 Article 702 and 738).
The device is not intended for use by persons (including children) with impaired or limited physical,
sensory and mental abilities or lack of experience and/or real knowledge, unless they are supervised
by a person responsible for their safety or you follow the instructions made by this person how to use
the device correctly.
Children should be supervised to make sure that they do not play with the device.
ATTENTION:
•
Run a visual inspection of the device before every use. Do not use the device if the safety ap-
pliances are damaged or worn out. Never override safety regulations.
•
Use the device exclusively according to the intended purpose stated in the instructions for
use.
•
You are responsible for the safety of the working environment.
•
If the cable or the plug is damaged due to external influences the cable must not be repaired!
It has to be replaced with a new one. This work can be carried out only by an electrician.
•
The voltage indicated on the type plate of the device of 230 Volt alternating voltage has to cor-
respond to the existent mains voltage.
•
Never lift, carry or fixate the device by using the power cable.
•
Make sure that the electrical plug connection is placed in a flood-proof area and is protected
from moisture.
•
Disconnect the mains plug before starting the maintenance work at the compressor
•
The user is responsible for complying with the location specific safety and mounting regula-
tions (you can ask an electrician)
•
In case of device failure the repairs can be carried out only by an electrician or by the WilTec-
.
repair service
HINWEISE:
•
Never expose the device to dust, acid, steam, explosive or flammable gases or atmospheric
influences (rain, sun, fog, snow).
•
Never allow children to touch the device if switched-on or to insert the plug. It may cause
burns or electric shocks.
•
When you start working make sure that all screws are tightened.
Properties:
7. The Airbrush spray booth can be folded together; it is light and needs little space.
8. It operates with low power consumption at a high airflow; it does not need an exhaust hose,
saves energy and protects the environment.
9. It has a very fine mesh filter that removes almost all colour and liquid particles without pollut-
ing the environment.
10. It has a power cord with the plug inside the unit; this can be pulled out if needed, at the push
of a button the cable is automatically loaded or pulled in.
5.
With transparent chamber divisions, two chambers can be combined for large work items if
needed.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.de
http://www.aoyue.eu
http://www.teichtip.de
.
Seite 18
Advertisement
