Advertisement
E420H extension tube installation notes (optional - sold separately)
,
The E420H is compatible with the spray booth E420. This combination leads to optimal result-sen. Not
only the paint mist is filtered, but also noxious fumes are passed through the HS-E420H hose. This
procedure makes the air in their workspace sau-ber and fresh.
1. Functions:
a) smart, lightweight, easy to assemble and disassemble.
b) The length of the hose can be varied from 0.7 to 1.7 meters.
c) The long flat exhaust can be pressed to 25mm from both sides, so that it fits in the window or door
gaps.
2. Parts List:
1. plastic sleeve
2.soft threaded
3.Hose Clamp
4. Extension tube
23. Exhaust port
3. Safety:
CAUTION:
1. When using the extension tube, take out a layer filter net from the spray booth. In the spray booth
are two layers filter network is used only one of which, if you use the extension hose.
2. Unscrew the 4 screws from the protective grille on the back of the HS-E420 spray booth. Explore
therefore you picture 1 on.
3. Use the 4 screws (you unscrewed in the previous step) to the plastic sleeve to connect (parts lists
piece 19) with the HS-E420 spray booth. You should research note the photo 2 on.
4. Screw the threaded sleeve soft (parts lists piece 20) and the extension hose (parts lists piece 22)
together and connect them to the extension tube to the exhaust opening (partial lists piece 23). Please
take a look to the photo 3 to
5. Insert the hose clamp (part lists piece 21) to the soft collet (part lists piece 20) and screw it into the
plastic sleeve (part lists piece 19). Explore to note the photo 4 to.
6. Extend. Hose to suit your needs and place it out of a window or door Explore to note the photo 5 to.
© by WilTec Wildanger Technik GmbH
Seite 25
http://www.wiltec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
