Table of Contents
Advertisement
3. CONTRAINDICATIONS
This device is not intended for any use other than that indicated. This device is
not designed, sold, or intended for use as a therapeutic device.
4. RELATED INFORMATION
Before using the AURA™ Monitor, read and follow all instructions, warnings, and
precautions provided in the AURA™ Monitor Pack manual and in the manuals for
the other system components. Manuals for the other system components are
listed below.
•
AURA™ Sensor Tray Instructions for Use
•
AURA™ Data Receiver Pack Instructions for Use
These manuals are also made available on the Internet and can be found at
www.auramonitor.com.
5. WARNINGS
There are no user-serviceable components inside this device. Refer servicing
to authorized personnel only. Unauthorized servicing, modification, or internal
access may be hazardous or damage the product.
Use only the Branchpoint Technologies supplied AURA™ Data Receiver and
software application with the AURA™ Monitor.
No modifications of this equipment are allowed unless approved by Branchpoint
Technologies. Additions or modifications may interfere with system
performance.
The AURA™ Monitor is MR Unsafe – keep away from magnetic resonance
imaging (MRI) equipment.
Do not subject the AURA™ Monitor to temperatures outside of the 0°C to 50°C
(32°F to 122°F) storage range. Exposure to high temperatures may cause the
AURA™ Monitor to overheat and may reduce its performance and service life.
The AURA
Monitor Pack components are only for use in non-condensing
TM
humidity conditions.
Do not discard the AURA™ Monitor in a fire or incinerate.
Do not immerse the AURA™ Monitor in liquid of any kind. AURA
permanently damaged if it is submerged in liquid. Continued usage after
submersion may result in further damage. If the AURA™ Monitor gets wet, turn
the device off, disconnect all cables, remove the battery, wipe the wet surfaces
dry, and contact Branchpoint Technologies customer service. Do NOT attempt to
dry the AURA™ Monitor in an oven, microwave, or dryer.
Only power the AURA™ Monitor with the provided lithium-ion batteries. Using
other sources of power may be hazardous or cause damage to the AURA™
Monitor. Only recharge the lithium-ion batteries with the provided charger and
power supply (REF# WSA515MD). Using other sources of power may be
hazardous or cause damage to the batteries.
The AURA™ Battery Charger should be positioned to allow immediate
disconnection from the supply mains. Connection and disconnection can be
established by plugging and unplugging the power supply from mains.
Always keep the spare battery charging while the other is in use to ensure
continuous availability of power. Change batteries as needed.
Never use a damaged battery or damaged AURA™ Monitor. Doing so could
result in user injury.
To avoid risk of electric shock, do not disassemble the AURA™ Monitor,
batteries, battery charger, power supply, or antenna.
2
Monitor will be
TM
Advertisement
Table of Contents
