Table of Contents
Advertisement
Press
to command the antenna to search for a sensor connection again.
NOTE: If
turn off to save power.
After successfully pairing with the AURA™ Sensor, The AURA™ Monitor is now
ready to pair with the AURA™ Data Receiver. Press
with the Data Receiver or open the menu and select "Pair Receiver."
PAIRING WITH AN AURA™ DATA RECEIVER
After pressing
the screen will ask the user to plug the AURA™ Data Receiver into the patient
monitor.
Ensure that the target AURA
(Figure 14) and is calibrated (see AURA
Use for directions).
Press
to continue pairing with a data receiver.
Select the serial number that matches the printed serial number on the label of
the AURA™ Data Receiver being paired to (Figure 15).
10
is not pressed within 2 minutes, the AURA™ Monitor will
to start pairing the AURA™ Monitor with the AURA™ Data Receiver,
Data Receiver is connected to the patient monitor
TM
Figure 14: AURA™ Data Receiver connecting into Patient Monitor IBP Port.
button to start paring
Data Receiver Pack Instructions for
TM
Advertisement
Table of Contents
