Safety; Camera; Network - Parrot ANAFI Thermal User Manual

Safety

Through Safety preferences, you can set a safe and clear flying area for
Set Thermal's maximum flight altitude with the "Max altitude" slider. This setting is
always activated, regardless of the activation of the Geofence.
To set a maximum distance from the pilot for your drone, move the "Max distance" slider to
the required value, then tap YES to activate the Geofence. When the Geofence is activated,
Thermal will automatically stop when it reaches the maximum distance you have
selected.
Max altitude
-
Max distance
-
Geofence
-
Minimum altitude when
-
using RTH
Tap "RESET ALL SAFETY PREFERENCES" on the bottom of the page to reset preferences.

Camera

Camera preferences enable you to select camera options, both in photo and video modes.
Camera calibration
-
Autorecord from take-off
-
Lossless zoom only
-
Display overexposure
-
Anti-flickering
-
About camera calibration: only resort to the "correct horizon" procedure if you notice your
videos and photos are systematically tilted on the same side. Refer to the "
calibration
" section of this guide for the detailed procedure.
About overexposure display: when this setting is activated, the HUD of FreeFlight 6 shows all
overexposed areas of the screen as hatched, which enables you to fine-tune your framing,
your EV settings, or both.
About Anti-flickering: this setting and the associated technology aim at eliminating the flicker
effect which can arise due to some artificial lights. The "AUTO" option should work for most
users, but depending on your country, you can try other settings if you feel bothered by a
flicker effect on your device's screen, your artificial light videos, or both.
Tap "RESET ALL CAMERA PREFERENCES AND SETTINGS" on the bottom of the page to reset
preferences (except for the Bracketing mode, which is only managed manually).

Network

Network preferences let you change your
and band.
36
0m to 150m (DV: 30m)
10m to 4000m (DV: 100m)
NO / YES
20m to 100m (DV: 30m)
Tap "CALIBRATE" to access camera & gimbal calibration
NO/ YES (video only)
NO / YES (selecting "YES" blocks zoom in JPEG RECT)
NO / YES
OFF / AUTO / 50Hz / 60 Hz
Thermal's Wi-Fi network name, password,
Thermal.
Camera