Specifications - Sony HT-DDW99 Operating Instructions Manual

Sony home theatre system operating instructions model htddw995
Table of Contents

Advertisement

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than 1%
total harmonic distortion from 250 milliwatts
to rated output.
Amplifier section
1)
Power Output
Models of area code U
Stereo mode (rated) (6 ohms 1 kHz
90 W + 90 W
Surround mode (reference) (6 ohms 1 kHz
THD 10%)
RMS output
FRONT: 140 W
per channel
CENTER: 140 W
SURROUND: 140 W
per channel
1)
Measured under the following conditions:
Area code
Power requirements
U
120 V AC, 60 Hz
2)
Reference power output for front, center and
surround speakers. Depending on the sound field
settings and the source, there may be no sound
output.
Inputs
Analog
Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
Outputs (Analog)
AUDIO OUT
Voltage: 800 mV/
10 kohms
SUBWOOFER
Voltage: 2 V/1 kohm
Tone
Gain levels
±6 dB, 1 dB step
Reproduction frequency range:
28 – 20,000 Hz
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
AM tuner section
Tuning range
With 10-kHz tuning scale:
With 9-kHz tuning scale:
Antenna
Intermediate frequency
3)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
, THD 1%)
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
,
erased when you change the tuning scale. To reset
2)
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Video section
Inputs/Outputs
Video:
COMPONENT VIDEO:
General
Power requirements
Area code
U
Power output (DIGITAL MEDIA PORT)
DC OUT:
Power consumption
Area code
U
Power consumption (during standby mode)
87.5 - 108.0 MHz
FM wire antenna
75 ohms, unbalanced
10.7 MHz
3)
530 – 1,710 kHz
3)
531 – 1,710 kHz
Loop antenna
450 kHz
1 Vp-p, 75 ohms
Y: 1 Vp-p, 75 ohms
P
/C
: 0.7 Vp-p,
B
B
75 ohms
P
/C
: 0.7 Vp-p,
R
R
75 ohms
80 MHz HD Pass Through
Power requirements
120 V AC, 60 Hz
5 V, 700 mA
Power consumption
200 W
0.3 W
continued
77
US

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Htd-dw995Str-k995Ss-msp900Ss-cnp680Ss-srp900Sa-wp780

Table of Contents