6: Selecting The Speaker System - Sony HT-DDW99 Operating Instructions Manual

Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAP017 remote commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 66).
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.
6: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
?/1
MULTI CHANNEL DECODING
SPEAKERS
(OFF/A/B/A+B)
AUTO CAL MIC
MEMORY/ TUNING
ENTER MODE TUNING
VIDEO 3 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R
SPEAKERS
(OFF/A/B/A+B)
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
To select
The speakers connected to the
SPEAKERS FRONT A terminals
The speakers connected to the
SPEAKERS FRONT B terminals
The speakers connected to both the
SPEAKERS FRONT A and B
terminals (parallel connection)
To turn off the speaker output, press
SPEAKERS (OFF/A/B/A+B) repeatedly until
the "SP A" and "SP B" indicators on the
display do not light up.
Note
You cannot switch the front speakers by pressing
SPEAKERS (OFF/A/B/A+B) when the headphones
are connected.
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
2CH A.F.D. MOVIE MUSIC
AUTO CAL MUTING
Light up
SP A
SP B
SP A and
SP B
29 US