Bionaire BU1300 Instruction Manual

BU1300IUK05EM2 V.qxd 6/28/05 16:18 Page 1
TROUBLE SHOOTING
PROBLEM CAUSE
Power light is off. Humidifier is not plugged in or Plug into power socket and turn the
humidity control switch is on the humidity control switch closckwise.
off ( ) position.
Power light is on but No water in tank. Humidity Fill the tank with water. Turn the humidity
no mist being emitted. control switch is on the control switch clockwise.
off ( ) position.
The water level is too high. Pour some of the water from the water
Power light is on but
tank inlet and replace the tank.
no mist being emitted.
Mist has bad odour. The machine is new or the Open the water tank and place the
water is not clean. appliance in a cool area for 12 hours.
Wash the tank out or change the water.
Little mist being The humidity control has scale, Wash the humidity control and change the
emitted. the water is dirty or has not water.
been changed for some time.
Clean the transducer softly with a damp
Scale covers the transducer
cotton ball. Transducer surface is delicate,
avoid applying excessive pressure.
For U.K. and Ireland only:
conforming to BS1363 standard. Replacement
3A fuse must be BSI or ASTA BS1362 approved.
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
GUARANTEE
plug of the correct type. Please refer to
PLEASE KEEP YOUR RECEIPT AS THIS WILL
"Installation of a plug" below.
BE REQUIRED FOR ANY CLAIMS UNDER THIS
Installation of a plug
GUARANTEE.
Applicable to U.K. and Ireland • This product is guaranteed for 2 years.
• In the unlikely event of breakdown, please
The wires in the mains lead are coloured as such:
take it back to the place of purchase, with
BROWN - LIVE
your till receipt and a copy of this guarantee.
BLUE - NEUTRAL
• The rights and benefits under this guarantee
Please note that the colour of these mains wires
are additional to your statutory rights which
may not correspond with the colour markings
are not affected by this guarantee.
that identify the terminals in your plug. Please
• Holmes Products Europe undertakes within
proceed as follows:
the specific period, to repair or replace free
The BROWN coloured wire must be connected
of charge, any part of the appliance found to
to the terminal, which is marked with the letter
be defective provided that
"L" or is coloured RED.
• We are promptly informed of the defect.
The BLUE coloured wire must be connected to
• The appliance has not been altered in any
the terminal, which is marked with the letter "N"
way or subjected to misuse or repair by a
or is coloured BLACK.
person other than a person authorised by
DO NOT CONNECT either of these wires to the
Holmes Products Europe.
earth terminal in the plug. The earth terminal
• No rights are given under this guarantee to a
plug is marked with the letter "E", or with the
person acquiring the appliance second hand
earth symbol or coloured GREEN and
or for commercial or communal uses.
YELLOW.
• Any repaired or replaced appliance will be
NOTE: If the terminals in the
guaranteed on these terms for the remaining
plug are not marked or if you
portion of the guarantee.
are unsure or in doubt about
THIS PRODUCT IS MANUFACTURED TO
the installation of the plug
3 amp
COMPLY WITH THE E.E.C. DIRECTIVES
please contact a qualified
73/23/EEC, 89/336/EEC AND 98/37/EEC.
electrician. If a 13A 3-pin
plug is fitted, it must be an
ASTA approved plug,
SOLUTION
Holmes Products (Europe) Ltd
Email: info-europe@theholmesgroup.com
UK - Filter Sales Order Line - 0870 759 9000
Website address: www.theholmesgroup.com/europe
UK - Free phone Customer Service Helpline – 0800 052 3615
1 Francis Grove
London SW19 4DT
England
Fax: +44 (0)20 8947 8272
9100030003550
BU1300IUK05EM2
ULTRASONIC
® ®
HUMIDIFIER
BU1300
INSTRUCTION MANUAL