Changing The Saw Rail And Saw Chain - Redback 106071 Operation Manual

Maintenance
The teeth on the saw chain are very sharp!
Wear protective gloves when handling the chain.
An incorrectly attached saw chain will cause the power tool
to cut in an uncontrolled manner!
When attaching the chain, observe the running direction!
Changing saw rail and saw chain
Place the pole saw on any suitable flat surface.
• Unscrew the hand wheel anti-clockwise until the saw rail can
be moved by hand
• Turn the chain tensioning wheel clockwise to push the saw
rail as far as possible onto the chain wheel 2.
• Detach the hand wheel
Figure 11).
• Place saw chain around the saw rail starting on the upper
part of the rail. Slide the chain in the slot around the saw rail.
When attaching the chain, ensure that it is in the correct
running direction.
• Place the saw chain around the chain wheel
• Place elongated hole of the saw rail on the stud bolt and the
guide bolt 6.
• Attach the chain guard
• Tighten the hand wheel slightly 8.
14
!
CAUTION
(see Figure 10).
1
3 and remove the chain cover
(see Figure 13).
7
4 (see
(see Figure 12).
5
Figure 10
Figure 11
Figure 12
Figure 13