Switching On/Off; Battery State Of Charge - Redback 106071 Operation Manual

Figure 7
Figure 8
Operation
Switching on/off the power tool
Switching on
Make certain that the saw chain has not yet
been positioned for cutting and is not
touching any other objects.
• Hold the saw firmly with both hands and ensure that there are no
people (particularly children) or animals in the immediate vicinity.
First press and hold the switch interlock
• Then press the On/Off switch 2.
Switching off
• Release the On/Off switch.
When the On/Off switch is released, the saw
chain continue running briefly.

Battery state of charge

• Press the button on the battery to check the state of charge at
the state of charge indicator LEDs (see Figure 8). The indicator
goes out after 5 seconds. If one of the LEDs flashes, the battery
must be recharged. If none of the LEDs light up after the button is
pressed, the battery is faulty and must be replaced.
Before each use
• Check that all parts of the power tool are present, firmly attached
and undamaged.
• Check that the chain tension is correct.
• Check the chain lubrication.
• Check that there are no leaks.
!
WARNING
(see Figure7).
1
!
WARNING
11