Selecting The Command Mode Of The Remote - Sony HT-6600DP Operating Instructions Manual

Remote Operations
Button
CLEAR DVD player
SEARCH DVD player
MODE
TOP MENU/ DVD player
GUIDE
Satellite tuner Displays guide menu.
AV MENU VCR/
Satellite tuner/
DVD player
O
VCD player/
LD player/
DVD player
V/v/B/b
VCR/
Satellite tuner/
DVD player
ENTER/ VCR/
EXECUTE Satellite tuner/ selection.
DVD player
TV ?/1
TV
-/-- TV
TV VOL TV
+/–
TV CH +/– TV
TV/ TV
VIDEO
WIDE TV
USE MODE Remote
AV1 and Remote
AV2
SOURCE Remote
ALT Remote
Function
Press if you made a
mistake when you press
the number button or
press to return to the
continuous play etc.
Select searching mode.
Press to select the unit
for search (track, index,
etc.)
Displays DVD title.
Displays menu.
Returns to the previous
menu or exits the menu.
Selects a menu item.
Press to enter the
Turns the TV on or off.
Selects the channel
entry mode, either one
or two digit.
Adjust the volume of
the TV.
Select preset TV
channels.
Selects input signal: TV
input or video input.
Selects the wide picture
mode.
To set up the remote.
Select the command
mode of the remote.
Selects 2ND AV
output.
Change remote key
function to activate
those buttons with
orange printing.
Notes
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• Press MAIN MENU on the remote before you use
the V/v/B/b buttons for receiver operation.
• Press TOP MENU/GUIDE or AV MENU on the
remote before you use the remote to control the
satellite tuner, VCR and DVD player.
• The VIDEO3, TV/SAT, PHONO, AUX, SOURCE,
DIRECT, AAC BI-LING, SB DECODING, 12 and
ON SCREEN functions are not available for set
operation.
Selecting the command
mode of the remote
Set the remote command mode using the USE
MODE button and the remote command mode
buttons.
Selecting the command mode
You can switch the command mode (AV1 or
AV2) of the remote. If the command mode of
the receiver and the remote is different, you
cannot use the remote to operate the receiver.
Press AV1 or AV2 while pressing down
USE MODE.
The indicator lights once (twice for AV2) , then
the command mode switches.
To check the command mode of the
remote
Press USE MODE. You can check the remote
by the indicator.
Mode
AV1
AV2
To reset the remote to factory
settings
Press =/1, AV =/1, and MASTER VOL – at
the same time.
The indicator lights 3 times, then goes off.
Indicator lights
once
twice
US
39