Selecting The Command Mode Of The Remote - Sony HT-4850DP Operating Instructions (primary manual) Operating Instructions Manual

Remote Operations
Button
H q; VCR/
CD player/
VCD player/
LD player/
DVD player/
MD deck/
DAT deck/
Tape deck
X qa VCR/
CD player/
VCD player/
LD player/
DVD player/
MD deck/
DAT deck/
Tape deck
x wa VCR/
CD player/
VCD player/
LD player/
DVD player/
MD deck/
DAT deck/
Tape deck
O qs VCD player/
LD player/
DVD player
-/-- ws TV
Notes
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• When you press input buttons (VIDEO1, VIDEO2 or
DVD), the input mode of the TV might not switch to
the corresponding input mode that you want. In this
case, press TV/VIDEO button to switch the input
mode of the TV.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
Function
Starts playback.
Pauses playback or
record. (Also starts
recording with
components in
recording standby.)
Stops playback.
Returns to the
previous menu or exits
the menu.
Selects the channel
entry mode, either one
or two digit.
Selecting the command
mode of the remote
Set the remote command mode using the RM
SET UP button and the remote command mode
buttons.
Selecting the command mode
You can switch the command mode (AV1 and
AV2) of the remote. If the command mode of
the receiver and the remote is different, you
cannot use the remote to operate the receiver.
Press AV1 or AV2 while holding down RM
SET UP.
The indicator flashes once (twice for AV2), then
the command mode switches.
To check the command mode of
the remote
Press RM SET UP. You can check the remote by
the indicator.
Mode
AV1
AV2
To reset the remote to factory
settings
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
Note
If the command mode of the receiver and the remote is
different, you cannot use the remote to operate the
receiver. To change the command mode of the
receiver, see page 41.
Indicator flashes
once
twice
35 US