Sony HT-6600DP Operating Instructions Manual page 48

Specifications (continued)
SA-WMSP85 for sub woofer
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz;
rated 100 watts, minimum RMS power, with no
more than 0.8% total harmonic distortion from
250 milliwatts to rated output (Models of area
code U only).
Speaker system
Speaker unit
Enclosure type
Continuous RMS power output
(6 ohms, 20 – 250 Hz)
Reproduction frequency range
High frequency cut-off frequency
Input
Power requirements
Area code
U, CA
Power consumption
Dimensions (w/h/d)
Mass
US
48
Active subwoofer,
magnetically shielded
Woofer: 20 cm cone type
Acoustically loaded bass
reflex
100 W
28 Hz – 200 Hz
150 Hz
LINE IN (input pin jacks)
Power requirements
120 V AC, 60 Hz
100 W
Approx. 10 3/4 × 12 7/8 ×
15 3/4 inches including
front panel
22 lb 1 oz
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
Speaker connecting cord, long (2)
Speaker connecting cord, short (3)
Monaural connecting cord (1 phono to 1 phono) (1)
Coaxial digital cord (1)
Foot pads (speakers) (20)
Foot pads (subwoofer) (4)
Remote commander (1)
R6 (size -AA) batteries (2)
Speakers
• Front speakers (2)
• Surround speakers (2)
• Center speaker (1)
• Sub woofer (1)
For details on the area code of the component you
are using, see page 4.
Design and specifications are subject to change
without notice.