Duct Connection - Best WTD9M Series Installation Instructions Manual

11. DUCT CONNECTION

Slide a 10" metal round duct over the adapter ring on top of the hood. Use metal foil duct
tape to seal the joint.
12. PREPARE AND INSTALL THE DECORATIVE FLUE
Remove the protective plastic film covering the lower flue only.
Peel off both corners at the top of the upper flue.
Position the lower flue rear notches down (the ones with the 45° angle).
Gently slide the upper flue inside the lower flue, making sure the holes are on the top, so
the upper flue can be screwed to the flue mounting bracket.
Carefully slide in place the decorative flues (notches end first) between the shaded parts
and the exterior wall of the top of the hood.
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must be
inside the flue. Secure it to the bracket using 2 no. 8 x 3/8" screws (from hood parts bag).
NOTE: Duct not shown in illustration to ease understanding.
Remove the protective plastic film covering the upper flue.
HJ0187
HO0342
U
PPER
FLUE
7
L
REAR NOTCH
HO0341
L
OWER FLUE
REAR NOTCH
S
HADED
PARTS
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
HO0140
OWER FLUE