Duct Length - Best WTT32I3 Manual

8. Align the two outer keyhole slots on the hood with the mounting screws that
were partially tightened into the wall framing. Ensure that hood is seated entirely
on mounting screws and that hood is level. Then tighten screws completely.
9. Install (2) 4mm x 38mm long screws into the holes inside the hood and tighten
them securely.
10. Reinstall grease filters by aligning rear filter tabs with slots in the hood. Pull
down the metal latch tab, push filters into position and release. Make sure
filters are securely engaged after installation.
8" ROUND STEEL DUCT
(10" for 48" wide hood)
DECORATIVE
FLUE
11. Measure and install steel ductwork to hood duct connector and ductwork
rough-in on ceiling or wall. Use duct tape to make all joints secure and air tight.
12. Plug power cord into wall outlet.

DUCT LENGTH

- 13 -