Blowing Feature - Emerson RIDGID RT14000 Owner's Manual

OPERATION
Moving the Wet/Dry Vac
Should it become necessary to pick
the Vac up to move it, the Handles
on each side of the Dust Drum or the
Powerhead Carry Handle should be used
to lift.
To maneuver the Vac, the Cart Push
Handle in the rear of the Vac should be
used.
Dust Drum
Handles (2)

Blowing Feature

Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
2. Align the Hose Release Button of the
Cart Push
Handle
Carry
3. (Optional) Attach the Extension Wand
Handle
4. Turn the Vac on and you are ready to
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
of injury to bystanders, keep them
clear of blowing debris.
!
blowing creates dust which might
be inhaled.
14
the Powerhead of your Wet/Dry Vac.
Professional Locking Hose End with the
Ridges on the Blower Port. Push the Hose
End straight into the Blower Port until the
Hose Release Button fully engages the
Blower Port Ridges.
to swivel end of the Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
use your Vac as a Blower.
WARNING: Always wear safety
WARNING: To reduce the risk
CAUTION: Wear a dust mask if