Supermicro M11SDV-4C-LN4F User Manual page 80

Super M11SDV-4C/4CT/8C/8CT/8C+-LN4F User's Manual
Note: If you are using a PCIe NVMe SSD as a boot device, configure the following BIOS
steps below:
1. Enable AMI Native Support in the Advanced > NVME Firmware Source menu.
2. After the installation is complete, enable Boot Option 1 for the NVMe device. Go to
Boot > UEFI Hard Disk Drive BBS Priorities > Boot Option # 1 > NVMe device.
3. Boot > Boot Option #1 > NVMe device.
M.2 (AHCI) Firmware Source
Use this feature to configure the M.2 (AHCI) Firmware Source. The options are Vendor
Defined Firmware and AMI Native Support.
CPU SLOT7 PCI-E 3.0 X16 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
M.2 PCI-E 3.0 X4 OPROM
Use this feature to select which option for the add-on card in this slot. The options are
Disabled, Legacy, and EFI.
Onboard LAN Option ROM Type
Use this feature to select which option for onboard LAN devices. The options are Legacy and
EFI. Select Legacy to display and configure the Onboard LAN1 ~ LAN8 Option ROM features.
Onboard LAN1 Option ROM
Use this feature to select which option for LAN Port 1 used for system boot. The options are
Disabled, PXE, and iSCSI.
Onboard LAN2 ~ LAN4 Option ROM
Use this feature to select which option for the specified LAN ports used for system boot. The
options are Disabled and PXE.
Onboard Video Option ROM
Use this feature to select the Onboard Video Option ROM type. The options are Disabled,
Legacy, and EFI.
CPU SLOT7 PCI-E 3.0 X16 Bifurcation
This feature is used to configure the PCIe slot bifucation.The options are Auto, x8x8, and
x4x4x4x4.
80