Warming Up Engine; Electric Start Models; Checks After Engine Warm Up; Shifting - Yamaha F300A Owner's Manual

gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU27670

Warming up engine

EMU41810

Electric start models

After the engine has started, warm up the en-
gine until the engine speed settles at idling
speed. The engine warming-up indicator is
shown on the Multi-Display while the engine
warms up. For further information, see page
36.
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU41820

Stop switches

Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
Check that the engine stops when the
●
main switch is turned to the "
sition, or press the Start/Stop button.
Check that the engine stops when the clip
●
is pulled from the engine shut-off switch.
Check that the engine cannot be started
●
with the clip removed from the engine
shut-off switch.
EMU35880
Selecting outboard motor
After all engines have started, set all control
levers to Neutral. Push the engine selector
switch repeatedly to change the digital elec-
tronic control-active indicator and select the
desired engine.
ZMU05848
1. Port side control lever
2. Starboard side control lever
3. Port side engine
4. Center engine
5. Starboard side engine
1. First, three engines can be operated.
Operation
(triple engine)
1
P C S
3
4 5
" (off) po-
2
ZMU05998
61