Cable Box Only - Sony KE-37XS910, KE-42XS910 Operating Instructions Manual

Cable Box Only

For best results, use this connection if:
s
Your cable company scrambles all channels, which requires you to use a
cable box.
s
You do not have a VCR. (If you have a VCR, see pages 30 and 32.)
With this connection you can:
s
Use the TV remote control to change channels coming through the cable
box to the TV's VHF/UHF jack. (You must first program the remote
control for your specific cable box.)
About Using This Connection with Dual Picture (Twin View, etc.) Features
With this connection, all channels come into the TV through your cable box and
only one unscrambled signal is sent to the TV, so you cannot use the dual picture
features. If some of your channels are scrambled, but others are not, consider using
the "Cable Box and Cable Only" on page 25 instead.
To connect the cable box
1
Connect the CATV cable to the cable box's input jack.
2
Use the supplied antenna cable to connect the cable box's output jack to
the TV's VHF/UHF jack.
3
Run the Auto Setup program, as described in "Setting Up the Channel
List" on page 48.
Antenna cable
CATV
(supplied)
cable
IN OUT
Cable box
Rear of TV
VHF/UHF
27