Advertisement
3 SPECIFICATIONS
The specifications for the VoltPAQ-X2 and -X4 systems are given in Table 3.1 below.
Specification
Mass
Dimension
Minimum Amplifier Specifica-
tions
Load Continuous Current Output
Amplifier Gain
Current Sense
Amplifier Command
Analog Sensors
Environmental
Protection Class
Analog Sensors Adapter Fuse
Amplifier Fuse
Voltage Rating
Frequency Rating
AC Current Rating
Caution: Precaution must be taken during the connection of this equipment to the AC outlet to make sure
the grounding (earthing) is in place and the ground wire is not disconnected.
Caution: Avoid covering the fan during operation to prevent premature thermal shutdown of the amplifier.
Caution: Do not position the equipment so that it is difficult to operate the on/off switch.
Caution: If the equipment is used in a manner not specified by the manufacturer, the protection provided by
the equipment may be impaired.
VOLTPAQ-X2 AND -X4 User Manual
VoltPAQ-X2
4.4 kg
0.39m × 0.33m × 0.10m
No load: -23.3 V to +21.8 V
2A load: -22.3 V to +20.8 V
4A load: -21.3 V to +20.3 V
Output voltage ±12V
Output current ±1.5A
(25% minimum cross loading required for negative supply)
• Standard rating
• Indoor use only
• Altitude up to 2000m
• Maximum relative humidity of 80% up to 31
linearly to 50% relative humidity at 40
• Pollution Degree 2
• Mains supply voltage fluctuations up to ±10% of the nomi-
nal voltage
• Maximum transient over-voltage 2500V
• Marked degree of protection to IEC 60529: Ordinary Equip-
ment (IPX0)
Class I
3A, 250V, 3AG Slow Blow
3A, 250V, 3AG Slow Blow
4.6A
Table 3.1: VoltPAQ-X2 and -X4 Specifications
VoltPAQ-X4
5.4 kg
0.39m × 0.33m × 0.10m
± 4 A
1 or 3 V/V (Gain selectable)
1 V/A
±10 V
◦
C
100-120V / 200-240V
50-60 Hz
8.3A
◦
C decreasing
v 1.0
Advertisement
