Advertisement
3 SPECIFICATIONS
Table 3.1 summarizes the specifications of the AMPAQ L2/L4 linear current amplifier system.
Specification
Mass
Dimension
Minimum Continuous Voltage Output
Maximum Continuous Voltage Output
Maximum Continuous Current Output
Peak Power Output
Amplifier Gain
Current Sense
Amplifier Command Range
Bandwidth in Current Mode
Input Impedance
Output Impedance
Environmental
Protection Class
Fuse
AC Voltage Rating
Frequency Rating
AC Current Rating
Caution: Precaution must be taken during the connection of this equipment to the AC outlet to make sure
the grounding (earthing) is in place and the ground wire is not disconnected.
Caution: Avoid covering the fan during operation to prevent premature thermal shutdown of the amplifier.
Caution: Do not position the equipment so that it is difficult to operate the on/off switch.
Caution: The AMPAQ L2/L4 devices are made to be used with Quanser designed experiment kits that have
particular actuators. Use caution if the AMPAQ L2/L4 is being used with your own actuator. Any
load to be used with the AMPAQ L2/L4 should have a minimum inductance of 0.1 mH.
AMPAQ L2/L4 User Manual
AMPAQ-L2
5.2kg
0.31m × 0.30m × 0.13m
No load: ±23V
2.5A load: ±20V
±24 V
2.5 A
280 W
0.5 A/V
2 A/V
±10 V
10 kHz
1 × 10
6
Ω
< 0.2 Ω
• Standard rating
• Indoor use only
• Altitude up to 2000m
• Maximum relative humidity of 80% up to 31
creasing linearly to 50% relative humidity at 40
• Pollution Degree 2
• Mains supply voltage fluctuations up to ±10% of the
nominal voltage
• Maximum transient overvoltage 2500V
• Marked degree of protection to IEC 60529: Ordinary
Equipment (IPX0)
Class I
5A, 250V, 3AG Slow Blow
100-120V / 220-240V
50/60 Hz
2.0 A
Table 3.1: AMPAQ L2/L4 specifications
AMPAQ-L4
6.8kg
◦
C de-
◦
C
4.1 A
v 1.1
Advertisement
