Viewing Pictures From Equipment Connected To The Tv - Sony Grand Wega KF-50SX300K Operating Instructions Manual

Connecting Audio Equipment to the TV
Conect your audio equipment to the audio output sockets D if you wish to amplify the audio output from TV. Next
, using the menu system, select the "Sound Adjustment" menu and set the "TV Speakers" to "One time off" or
"Permanent off" (see page 15).
The volume of the external speakers can be altered by pressing the volume buttons on the remote control. The
Treble and Bass settings can also be altered through the "Sound Adjustment" menu (see page 14).
To enjoy "Dolby Virtual" sound effect through your
audio equipment
Place the speakers of your equipment in front of your listening position and
beside the TV set, keeping a distance of 50 cm between each speaker and the
TV set.
Then by using the menu system, select the menu "Sound Adjustment". Next
select "Dolby Virtual" on the "Sound Effect" option (see page 14).
Viewing pictures from equipment connected to the
TV
1
Connect your equipment to the designated TV socket, as indicated in the previous page.
2
Switch on the connected equipment.
3
To watch the picture of the connected equipment, press the
input symbol appears on the screen.
Symbol
1
1
2
2
3
3
S
4
4
S
5
4
Press the
For Mono Equipment
Connect the phono plug to the L/G/S/I socket on the front of the TV and select
signal using the instructions above. Next, refer to the "Sound Adjustment" section of this manual and
set "Dual Sound" option to "A" on the sound menu screen (see page 14).
Input Signals
• Audio / video input signal through the Scart connector G
• RGB input signal through the Scart connector G. This symbol appears only if an
RGB source has been connected.
• Audio / video input signal through the Scart connector F.
• RGB input signal through the Scart connector F. This symbol appears only if an
RGB source has been connected.
• Audio/video input signal through the Scart connector E.
• S Video Input signal through the Scart connector E. This symbol appears only if
an S Video source has been connected.
• Video input signal through the phono socket B and Audio input signal through
C.
• S Video Input signal through the front S Video input jack A and Audio signal
through C. This symbol appears only if an S Video source has been connected.
• RGB input signal through the PC connector H and I.
button on the remote control to return to the normal TV picture.
Hi-Fi speakers
~50°
Your sitting position
button repeatedly until the correct
4 or 4 input
S
Additional Information
GB
25