Product Overview; Controls - Toro Workman HDX-D 07385 Original Instructions Manual

Product Overview

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Control Panel
1. Light switch
2. High-flow hydraulics
switch (TC models only)
3. Horn (TC models only)
4. Tachometer
5. Hour meter
6. Speedometer
7. Coolant-temperature
gauge and light
8. Fuel gauge
Accelerator Pedal
Use the accelerator pedal
speed of the machine when the transmission is in
gear. Pressing down the accelerator pedal increases
the engine speed and ground speed. Releasing the
pedal decreases the engine speed and ground speed.
Figure 5
9. Key switch
10. Power point
11. Third high lockout switch
12. Oil-pressure-warning light
13. Glow-plug indicator
14. Charge indicator
15. 4-wheel drive switch
(4-wheel drive models
only)
(Figure 6) to vary the ground
1. Clutch pedal
2. Brake pedal
Clutch Pedal
You must fully press the clutch pedal
to disengage the clutch when starting the engine
or shifting transmission gears. Release the pedal
smoothly when the transmission is in gear to prevent
unnecessary wear on the transmission and other
related parts.
g240582
Important:
Do not ride the clutch pedal during
operation. The clutch pedal must be fully out or
the clutch slips, causing heat and wear. Never
hold the machine stopped on a hill using the
clutch pedal. Damage to the clutch may occur.
Brake Pedal
Use the brake pedal to stop or slow the machine
(Figure 6).
CAUTION
Operating a machine with worn or incorrectly
adjusted brakes can may result in personal
injury.
If the brake pedal travels to within 25 mm (1
inch) of the machine floor board, adjust or
repair the brakes.
14
Figure 6
3. Accelerator pedal
(Figure
g036549
6)