Table of Contents
Advertisement
Quick Links
The Trolley™
Monitor lift System
s
Parts List
The Trolley™
Tools (not included)
Phillips Screwdriver
Power screwdriver may also be used.
Note: Do not connect the Trolley™ to power source until step 4
Step 1:
b.
Step 2:
a.
Need assistance? Call 1-800-730-6682 for NOVA Solutions Customer Support
Installation & Operating Instructions
Removable Metal
Front Cover
1a. Remove Trolley™ and parts from shipping box.
1b. Place Trolley™ in it's upright, vertical position
with the open interior side facing you.
2a. With arm in down
position, remove
black cable
management
cover.
Qty. 4
Locking Plates
100mm VESA
Plate
Qty. 4
10-24 x 3/4
Shorter
Qty. 4
8-32 x 7/8
Locking Plate Screw,
Longer
Qty. 1
Pan head #10 x 5/8
Black Screw for
front cover
Qty. 1
4mm x 0.7
Anti-tilt screw, black
(Pre-installed in
Tounge of VESA Plate
2b. Remove right
screw from cable
retention clip on
cable management
channel. Then
loosen left screw
and rotate clip
downward.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Nova Trolley
Summary of Contents for Nova Trolley
- Page 1 Locking Plate Screw, Phillips Screwdriver Longer Power screwdriver may also be used. Note: Do not connect the Trolley™ to power source until step 4 Step 1: 1a. Remove Trolley™ and parts from shipping box. 1b. Place Trolley™ in it’s upright, vertical position with the open interior side facing you.
- Page 2 Trolley™ on work surface adjacent to work surface cutout. 4f. Plug the Trolley™ into power source. Wait 5 seconds to activate, then push the UP button to open door and Feed video and power cables through raise the Trolley™...
- Page 3 Slide bottom of cover into Trolley™ aligning with screw hole. Reinstall the screw. (H) Pan head #10 x 5/8 Black Screw for front cover Page 3 of 4 Need assistance? Call 1-800-730-6682 for NOVA Solutions Customer Support...
- Page 4 Monitor lift System Overview The Trolley™ EXL includes Intelligent Motion Technology™. This feature reduces the risk of accidental damage and personal injury. Utilizing information from various different sensors, Intelligent Motion Technology™ continually monitors the Trolley’s™ opperational status and delivers information to the power control module.
- Page 5 Retro Trolley Install Instructions - Dual Trolley Addendum...
- Page 6 Fig. A Fig. A After placing Retro Dual Trolley in worksurface cutout, remove these two screws to install Center Locking Plates. (See Fig. B)
- Page 7 The through-hole is slightly larger and the overall length is shorter. Center Locking Plate Locking Plate Screw Fig. B Attach Center Locking Plates using screws removed in Fig. A. Tighten Locking Plate Screw to underside of worksurface to secure Retro Dual Trolley.
- Page 8 Fig. C Once Retro Dual Trolley is secured in place, connect the two Black USB cables on the back side of the Retro Dual Trolley.
Need help?
Do you have a question about the Trolley and is the answer not in the manual?
Questions and answers