Table of Contents
Advertisement
B. Demagnetization (without going through the
DEMAG
B1. Press the key
The following screen displays :
<->
DEMAG
DETECT
DEMAG
B2. Place the object to be demagnetized on the demagnetizing surface DEMAG ZONE and press the
The device starts its demagnetization cycle.
The following screen displays during the demagnetization cycle :
<->
DEMAG
DETECT
DEMAG
Note :
At the end of the cycle, move the object to the DETECT ZONE surface and press the
If a remanence is detected (see the screen below with the red dots), the demagnetization process must be repeated by
DEMAG
pressing the
key again. Repeat this operation until a display of 0 μT is obtained.
<->
DETECT
DEMAG
200 µT
Press the
key to return to the main menu
MAGTEST
on the main menu
Display of the submenu
Display of the submenu
heard during the cycle. We will also see that the
and cross each other throughout the cycle)
MAGTEST
DETECT
function)
to demagnetize the object.
DEMAG
DEMAG
in demagnetization mode (beeps are
DETECT
.
11
DEMAG
key.
S
N
and
poles flash
key.
Advertisement
Table of Contents
