Table of Contents
Advertisement
Setup Menu
To input your favorite tracks/chapter
3 Use the numeric keypad (0-9) to enter
a valid track/chapter number.
4 Use 1 234 to move the cursor to the
next position.
➜ If the track number is more than ten,
press T to open the next page and
proceed with programming or,
➜ Use 1 234 to highlight {NEXT} on the
program menu, then press ENTER/
OK.
5 Repeat steps 3–4 to input another track/
chapter number.
If you want to remove a track
6 Use 1 234 to move the cursor to the
track you want to remove.
7 Press ENTER/OK to remove this track
from the program menu.
Note:
– On SA-CD discs, you can program tracks on
the CD layer.
Program: Disc
You can play the disc in the order you
want by programming the discs to be
played. Up to 5 discs can be stored.
1 In 'GENERAL SETUP PAGE', press 34 to
highlight {PROGRAM}, then press 2 to
select {FDS}.
2 Press ENTER/OK to confirm.
(1) Disc : _
(2) Disc : _
(3) Disc : _
(4) Disc : _
(5) Disc : _
TIPS:
To return to the previous menu, press 1.
To remove the menu, press SETUP.
22
To input your favorite discs
3 Use the numeric keypad (0-9) to enter
a valid disc number.
4 Use 1 234 to move the cursor to the
next position.
5 Repeat steps 3–4 to input another disc
number.
If you want to remove a disc
6 Use 1 234 to move the cursor to the
disc you want to remove.
7 Use the numeric keypad (0-9), press 0
to remove this disc from the program
menu.
To start program playback
• Use 1 234 to highlight {START} on
the program menu, then press ENTER/
OK.
➜ Playback will start with the selected
tracks or discs under the programmed
sequence.
To exit program playback
• Use 1 234 to highlight {EXIT} on the
program menu, then press ENTER/
OK.
Advertisement
Table of Contents
