Neutral Adjustment; Neutral Lockout And Tracking Adjustment - Ferris SRS Z3X Series Operator's Manual

figure is intended to help you better understand the available
cutting heights for this unit.
42
To set the cutting height at 1-3/4" (4,5 cm):
1. Pull the deck lift lever (A, Figure 43) back towards the
operator position until it locks into the 5" (12,7 cm)
TRANSPORT position.
43
2. Remove the cutting height adjustment pin (B) from the
hole that it is installed in and put it in the storage location
hole (A, Figure 42).
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button (C, Figure 43) to
release the transport position lock.
32
4. Push the deck lift lever forward until it contacts the
stationary pin in the 1-3/4" (4,5 cm) hole.
To set the cutting height in the range of 2" (5,08 cm) and
4-3/4" (12,1 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2. Place the cutting height adjustment pin in the desired
cutting height hole.
3. Pull the deck lift lever back towards the operator position
and depress the deck lift release button to release the
transport position lock.
4. Push the deck lift lever forward until it contacts the cutting
height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1. Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2. Place the cutting height adjustment pin in any open hole.
The deck lift lock latch (D) holds the mower deck at the
5" (12,7 cm) position while cutting.
Note: Make sure that the cutting height adjustment pin is
inserted into the holes in both upper and lower plates of the
pin box (E).

Neutral Adjustment

The neutral system for this mower is a function of the
transaxles.
1. Drive the machine to a flat, level surface. Engage the
parking brake and disengage the PTO.
2. Without touching the forward speed control levers
disengage the parking brake. If the unit moves, the
neutral systems on the transaxles are not correctly
adjusted. See your dealer.
Neutral Lockout and Tracking
Adjustment
Before making adjustments to the neutral lockout or the
unit's tracking, be sure to check the following:
• Drive tires are properly inflated.
• Caster tires are greased and turn freely.
• All controls are free from damage and operate freely.
• Machine is at full operating temperature.
• Make sure that the machine is in NEUTRAL when
the ground speed control levers are released per the
procedure detailed in Neutral Adjustment.
Positioning the Parking Brake Handle
1. Park the machine on a flat level surface such as a
concrete floor. Disengage the PTO, engage the parking
brake, turn the ignition switch to OFF, and remove the
ignition key.
2. Chock the front wheels of the unit to prevent movement
and disengage the parking brake.
3. Engage the parking brake by pulling the parking brake
lever (A, Figure 44) up and back while moving both
ferrismowers.com