Important Safety Instructions; Pre-Installation - Da-Lite Cosmopolitan Electrol Instruction Book

When using your video equipment, basic safety precautions should always be followed, including the
following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized
service dealer when repair work is required. Incorrect reassembly can cause electric shock when
the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.

PRE-INSTALLATION

1. Carefully unpack screen and remove outer wrapping from case.
2. Do not remove black tape from screen.
3. Always handle screen in upright position.
INSTALLATION
There are three methods of mounting to include:
Flush against wall; Suspended from ceiling (use extension brackets); and Recessed above ceiling.
CEILING HANGING
PICTURE SURFACE
NOTE: Under no circumstances should unit be completely sealed in recessed installation. Allow access for service. Picture surface
is centered in case. Case extends 4" beyond surface on either end. Do not attach anything to screen slat rod or bottom fabric pocket.
1. Make sure screen is level. Use a carpenter's level and plum level.
!
CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand.
2. Remove tape from slat pocket.
3. Install electrical hook up that applies to your unit. Make sure to review your Electrical Installation Checklists and
wiring diagrams (included) for either 120 volt switch, 220/240 volt switch, or DRC low voltage control.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
CONCEALED (ALLOW ROOM FOR ACCESS)
WALL MOUNTED
PICTURE SURFACE
FIGURE 1
PICTURE
SURFACE
1
USE NO. 6 BRACKETS
TO HANG BEHIND
BEAM OR VALANCE
PICTURE
SURFACE