Protection From Overheating - TESY WFE200SREL Installation, Operation And Storage Manual

REMOTE CONTROL MODE
EN
•
First, you need to turn on the switch
for stand-by mode.
•
The appliance is equipped with
electronic thermoregulator and the
possibility to adjust the ambient
temperature within the range of
15÷30°С (reaching the desired
temperature will depend on many
factors like the size of the room to be
heated, insulation, etc.). Setting the
temperature is done by two buttons
(T- and T+).
•
It takes some time for the receiver to get the
commands from the remote control. Don't press the
buttons more than once within 2 seconds time, if
you wish the appliance to work properly.
•
Press the О/I (
once T-his switches on/off the appliance and the
flame effect.
•
Press once the 1000W button for low heating power,
and press it twice for switching off.
•
Press once the 2000W button for high heating
power, and press it twice for switching off.
•
By the DIMMER button you can adjust up to 5 levels
of light emanation from the electric fireplace.

PROTECTION FROM OVERHEATING

This appliance is equipped with safety thermal
disconnection device, which is actuated at high
temperature (resulting for example from blocking of
the outlets for outgoing air). For safety purposes the
thermal disconnection device will not be automatically
restarted. In order for it to be restarted, you need to
take the power cord out of the socket, wait for about
10 minutes and then put the plug in the socket again.
Normally the appliance will start operating, but if this
doesn't happen, you need to check the inlet and outlet
openings. If everything is normal with them (and the
appliance has been regularly cleaned from dust), please
contact the service center in your location.
To avoid the risk of involuntary restart of the
thermal disconnection device, you should not
connect any external starting devices such as timers,
series connection switches which provide regular
switching on and off of the appliance for the sake of
convenience.
6
Usage and Storage Instructions
) button on the remote control
CLEANING
•
It is compulsory first to switch off the appliance and
disconnect its power cord from the socket on the
wall. Before starting to clean the electric fireplace
you should wait until it cools down.
•
Clean the body of the appliance with a damp cloth,
vacuum cleaner or soft brush.
•
Never immerse the appliance into water – there is
risk for your life from electric shock!
•
Never use petrol, thinner or coarse abrasive
products for cleaning because they will damage the
surface coating of the appliance.
STORAGE
•
Before putting away the electric fireplace let it cool
down after disconnecting it from the power socket.
•
Use the original packing for storing the electric
fireplace if it will not be used for a certain period of
time. The product is protected from excessive dust
and dirt when it is kept in its original packing.
•
Never put a hot appliance into its packing!
•
The product is necessary to be stored at a dry place
away from direct sunlight.
•
It is explicitly forbidden to store the appliance in
wet or damp premises.
PRODUCT PACKING SET INCLUDES:
Fireplace
Clamp for wall-mounting
Mounting screws and securing element
Remote control
Manual
Guarantee certificate
TECHNICAL CHARACTERISTICS OF THE
APPLIANCE:
Lightening – LED system (no replacement parts)
Model Rated power
WEF200SREL 2000W
Warning: In order to avoid
overheating, do not cover the fireplace!
Environment protection instructions
Old electric appliances contain valuable materials
and therefore should not be disposed of as domestic
waste! We ask you for your active cooperation to
protect the resources and the environment by
submitting your appliance to organized buy-back
stations (if there are such).
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
Rated voltage Rated
frequency
220-240V~ 50Hz