Using The Fireplace; Manual Mode - TESY WFE200SREL Installation, Operation And Storage Manual

•
A height of 600 mm from the floor is recommended
for optimal visualization of the flame effect (see Fig.
1 for recommended dimension for mounting).
•
For optimal visualization, mark the positions of the
top four screws for wall-mounting in accordance
with the recommended dimension for mounting
(see Fig. 2. Openings with 6 mm drill bits).
•
Mount the bearing clamp to the wall by the screws.
•
Carefully lift the fireplace upwards so that the upper
rear edge of the fireplace to lie over the bearing
plate fixed on the wall (see Fig. 2.) and position it
centrally.
•
Carefully press the fireplace to the wall.
•
Mark the position of the bottom openings (see
Fig. 3), remove the fireplace, ensuring that the
lower mounting plate is turned and will not be an
obstacle.
•
Drill the openings for the bottom holes and fix on
the wall.
•
Place the fireplace on the bearing clamp, fixed on
the wall, and turn the clamp to fix the lower part.
Use the securing screw to permanently mount
the fireplace to the wall and to protect it from
unhanging.
English
•
Unpack the river pebbles from the polyethylene bag
and place them along the light-emitting element in
the configuration and position you wish.
•
Place the front glass in front of the arranged
pebbles ensuring that each pair of grooves
from both sides are properly aligned towards to
supporting axes (see Fig.4). Usually two people can
accomplish this operation.
Note: During appliance operation in areas with very
low level of background noise, it is possible specific
sound to be heard which is related to the flame effect. This
is normal and should not be considered worrying.

USING THE FIREPLACE

The fireplace can be operated by the switching knobs
located in the upper right part of the appliance or by the
remote control.

MANUAL MODE

•
The appliance can be operated manually by the
switching knobs located in the upper right part of
the appliance. First, you need to turn on the switch
for stand-by mode.
•
Press the О/I ( ) button once to turn on the
appliance and start the flame effect. When this
function is on, a red indicator lamp will flash.
Pressing the О/I ( ) button for 3 seconds will
enabled a dimmer mode; hold the button pressed
until you reach the desired brightness.
•
Press once the 1000W button for low heating power,
and press it twice for switching off.
•
Press once the 2000W button for high heating
power, and press it twice for switching off.
Usage and Storage Instructions
EN
5