Sony MZ-NH900 Setup Manual page 5

Himd recorders

Hide thumbs Also See for MZ-NH900:

10. Slip the mic back into the shock mount and attach the fake fur

jacket. The Rode NT-4 mic is very sensitive to hand-holding and the

slightest amount of wind. Unless you are mounting it on a mic stand

indoors, the results are likely to be disappointing without a shock

mount/zepplin.

11. Its best to turn ON the mic before plugging it in to the Recorder. The

switch is on the Mic body ON. When the NT4 is switched ON, the red

battery status light should illuminate for about 1 second and turn off.

the L.E.D. remains illuminated significantly longer, the battery should be

replaced. Life expectancy for a high quality alkaline battery is in excess

of 400 hours.

depleted.

12.

Attach the XLR-> 1/8" stereo mini-plug cable to the end of the

NT4 mic.

Plug the mini-plug connector into the RED mic in jack on

the Sony Recorder and the headphones into the black headphone

jack.

Headphone OUT

13.

Set/Check Mic Sensitivity

Navi/Menu button for 2 seconds until the menu window activates. Use

Jog Wheel to navigate to "Rec Set" and then "Mic Sens." Select

"High" if you are recording ambience or "Low" if you are recording

close voice or loud sound effects.

14.

Set in Manual Record Level Mode

directly into Manual Record Mode; you must go into Auto Gain mode,

If left ON, the battery power will be unnecessarily

(Low or HI) Press and hold the

MIC IN

Unfortunately, one cannot go