Sony MZ-NH900 Setup Manual page 4

Himd recorders

Hide thumbs Also See for MZ-NH900:

Set to Advanced Menu Mode

for 2 seconds until the menu window activates. Rotate the circular jog

wheel until the word,

ENTER button (the button in the middle of the Jog wheel) to select

"Option." Rotate the jog wheel until the word "Advanced" is blinking

and select it by pressing ENTER. You cannot access manual record

gain unless it is in this mode.

"EOR" (EDIT; OPTION; RECORD SET)

Format Disc in MD format (this erases everything that is already

recorded on the disk)

seconds until the menu window activates. Rotate jog wheel to EDIT,

select it by pressing the ENTER button in the center of the Jog

Wheel. Under Edit-> select Format-> and blinking "Yes." If there is

no "Format" option provided, select "Erase All."

blinking. Select "Disc Mode" by pressing ENTER. Jog until the word,

"MD" is blinking. Select it with ENTER.

Set Disc Mode in MD format

2 seconds until the menu window activates. Rotate jog wheel to

Option, select it by pressing the ENTER button in the center of the

Jog Wheel. Under Option-> select Disc Mode-> and blinking "MD."

Set Record Mode to SP

seconds until the menu window activates. Rotate Jog Wheel until

"REC Set" is blinking and press Enter. Select "Rec Mode" and then

"SP."

8. Look at the Menu window. The Record Mode should show "MD" and

"SP. If the window shows HiMD or LP2, re-do the above steps 5 and

7 .

9. Install a fresh, alkaline, 9 volt battery into the Rode NT-4 mic by un-

screwing the lower section of the body and sliding the battery into the

cavity (terminals first). Check for correct polarity (+ to + and – to –).

Secure the battery in place with the flexible spring clip and screw the

sections back together.

Press and hold the Navi/Menu button

"Option," is blinking. Press down on the small

Press and hold the Navi/Menu button for 2

Press and hold the Navi/Menu button for

Press and hold the Navi/Menu button for 2

"Disc Mode" is