Table of Contents
Advertisement
Quick Links
Smart Connect Quick Start Guide
Neckloop
Volume
Down
Charging
Port
Before you begin:
•
Charge Smart Connect for 2 hours with provided charger and cable
•
Neckloop must be securely connected: no metal showing
•
Hearing aids must be First Fit and programmed by hearing care
professional
•
Hearing aids must have fresh batteries
•
Hearing aids and Smart Connect should be in wearing position or
the hearing aids may be on a flat surface within 6 inches of the
neckloop
•
If a cell phone will be used, it should be within reach
•
Verify that the Smart Connect is off. If any LED blinks when
pressing any button, press and hold the MFB for 2 to 5 seconds to
turn off.
This is not a substitution for reading your Owner's Manual. For more
In depth instructions, please refer to your Owner's Manual.
Green LED
Blue LED
Volume
Up
Orange LED
Multi Function
Button (MFB)
Reset: single hole
near the base
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for connexx Smart Connect
Summary of Contents for connexx Smart Connect
- Page 1 If a cell phone will be used, it should be within reach • Verify that the Smart Connect is off. If any LED blinks when pressing any button, press and hold the MFB for 2 to 5 seconds to turn off.
- Page 2 First Time Pairing Smart Connect to Transmitter 1. Verify that the Smart Connect is on by pressing any button. If it is on the green LED will blink. If it is not on, press and hold the MFB button for 2 to 5 seconds until the green light blinks.
-
Page 3: Daily Use
Daily Use 1. Place the hearing aids in the ears and turn them on. 2. Place the Smart Connect around your neck, as shown in the picture. 3. Press and hold the MFB for 2 to 5 seconds to turn on the Smart Connect. The green light will flash until it connects to the hearing aids, then it will go solid briefly and turn off. -
Page 4: Troubleshooting
Check that the Smart Connect is the selected audio (iPhone only) • Close all other apps on the phone • Restart the phone or audio streaming device • If hard wired to Smart Connect, verify cable is securely connected or replace cable Blue light remains on • Press MFB •...
Need help?
Do you have a question about the Smart Connect and is the answer not in the manual?
Questions and answers