11. Install spare wheel on wheel
hub. Insert wheel bolts and
tighten them slightly.
To avoid paint damage, place
wheel flat against hub and
hold it there while installing
first wheel bolt.
Unscrew the alignment bolt to
install the last wheel bolt.
12. Lower car. Remove jack and
insert jack tube cover.
13. Unfold wrench and tighten the
five bolts evenly, following the
sequence illustrated above,
until all bolts are tight.
Observe a tightening torque of
110 ft.lb. (150 Nm).
14. Correct tire pressure.
Important!
When installing new wheels the
mounting bolts must be retight
ened after approx. 60 - 300 miles
(100 to 500 km).
Before storing the jack, the jack
arm must be lowered almost to the
base of the jack.
Warning!
Incorrect mounting bolts or
improperly tightened mount
ing bolts can cause the wheel
to come off. This could cause
an accident. Be sure to use
the correct mounting bolts.
P40 0027 B13
101