Tascam 208i Series Reference Manual page 18

5 - Using the Settings Panel
Output adjustment section
1 REVERB button
Click the REVERB button to apply reverb.
(Default: on)
When the reverb is on, the REVERB button lights.
NOTE
The reverb cannot be turned on if the sampling frequency is
176.4/192 kHz.
2 RETURN knob and indicator
Use to adjust the return level, which is the signal from the
reverb effect returned to the stereo bus.
Range: -inf. to 6 dB (default: -inf.)
Drag the RETURN knob up or down to adjust the return level.
While dragging, the value being adjusted is shown below
and to the right of the RETURN knob.
The indicator lights blue at levels of 0 dB or less and yellow at
levels from 0 dB to 6 dB.
18
TASCAM SERIES 102i / SERIES 208i
3 AUX MASTER 1/REVERB knob and indicator
Use this to adjust the send master level of the signal sent to
the AUX 1 bus and reverb effect.
Range: -inf. to 6 dB (default: 0 dB)
Drag the 1/REVERB knob up or down to adjust the send level.
While dragging, the value being adjusted is shown below
and to the right of the 1/REVERB knob.
The indicator lights blue at levels of 0 dB or less and yellow at
levels from 0 dB to 6 dB.
4 AUX MASTER 2-4 knobs and indicators
Use these to adjust the send master levels of the signals sent
to the AUX 2-4 buses.
Range: -inf. to 6 dB (default: 0 dB)
Drag the 2-4 knobs up or down to adjust the send levels.
While dragging, the value being adjusted is shown below
and to the right of the 2-4 knob.
The indicator lights blue at levels of 0 dB or less and yellow at
levels from 0 dB to 6 dB.
5 MUTE button
This mutes the STEREO MASTER output. (Default: off )
6 STEREO MASTER fader
Use this to adjust the level of the output signal.
Range: -infinity to 6.0 dB (default: 0.0 dB)
Drag the STEREO MASTER fader up or down to adjust the
master level.
The value being adjusted is shown in the STEREO MASTER
fader level display area (8).
7 STEREO MASTER level meters
The master levels are shown by this stereo level meter.
The STEREO MASTER level meters appear green at levels of
-12 dB or less, yellow at levels from -12 dB to -6 dB and red at
levels above -6 dB.
Each level meter has an overload indicator at its top.
NOTE
The STEREO MASTER level meter shows the levels after
being adjusted by the fader (post fader). The level meters are
affected by fader adjustments and channels being muted.
8 STEREO MASTER fader level display area
This shows the level of the STEREO MASTER fader as a decibel
value.