Tascam 208i Series Reference Manual page 17

0 Pan slider
Use to adjust the stereo positions of the signals input to each
channel.
Drag the pan slider left or right to adjust the stereo position.
While dragging, the adjusted position is shown above the
channel level meter (w).
The value is L20 when set all the way to the left, R20 when set
all the way to the right and C when centered.
Setting range: L20 - L1, C (default), R1 - R20
The pan slider appears blue when centered (C) and yellow at
all other positions.
NOTE
i When the pan slider is centered (C), signals reduced by 3 dB
are sent to both the stereo left and right buses.
i Double-click the pan slider to return it to the center (C)
position.
i When the pan slider is at the left end (L20), the signal is sent
only to the left bus of the stereo bus. It is not sent to the right
bus.
i When the pan slider is at the right end (R20), the signal is
sent only to the right bus of the stereo bus. It is not sent to
the left bus.
q Channel fader
Use these to adjust the levels of the signals sent from each
channel to the stereo bus.
Range: -infinity to 6.0 dB (default: 0.0 dB)
Drag a channel fader up or down to adjust the channel level.
The gain value of the channel fader is shown in the fader
level display area (e).
NOTE
Shift-click the fader to set it to 0 dB.
w Channel level meter
These meter show the signal levels of each channel.
The channel level meter appear green at levels of -12 dB or
less, yellow at levels from -12 dB to -6 dB and red at levels
above -6 dB.
Each level meter has an overload indicator at its top.
NOTE
The channel meter show the level before being adjusted by
the fader. Level meter are not affected by fader adjustment or
even their channel being muted.
e Fader level display area
These show the level of the channel fader above them as
decibel value.
r LINK button
Click a LINK button to unite odd and even channel as a single
stereo channel. When linked, this button lights for those
channel. (Default: off )
When a pair is stereo linked, the buttons and knobs of the
channels are combined. The channel level meters are also
shown is a stereo pair.
See "LINK button overview" on page 19 for details.
5 - Using the Settings Panel
t Channel note
You can input up to six alphanumeric characters.
Character input
i Click one of these areas. The cursor will blink when
ready for input. When the unit is ready, use a computer
keyboard to input characters. When done inputting, press
the computer Enter key to confirm.
i When done inputting characters, you must press the
computer Enter key to confirm. If you do not press the
Enter key before switching from the MIXER page to a
different page, the input characters will continue to be
shown but will not be saved.
TASCAM SERIES 102i / SERIES 208i
17