Table of Contents
Advertisement
1
Read this First
The safety precautions that should always be followed in order to prevent injury to user or other individuals as well as
prevent damage to property are described below.
The level of injury or damage caused by ignoring these safety precautions and using the product improperly is categorized
and described below.
This icon indicates an action with the potential to
Warning
cause death or serious injury.
To prevent from short-circuits or damage, observe the following:
Be sure the power is disconnected before replacement or repair, including the replacement of the fuse.
Use this product in a properly maintained condition. (Replace or repair if the globe, case, etc. are damaged.)
If installing this product requires construction work, ask a specialist in order to avoid fi re, or personal injury.
When this product is used for security purposes, it should be inspected daily. In case a malfunction should occur, it is
recommended that you use this product together with other security products.
After installation, do not use this product to climb up onto the equipment with.
Failure to comply will result in product damage and/or falling off the machinery.
Be sure to put a fuse in the wiring circuit between the power source and equipment for protection. If a fuse is not added,
it may result in product and/or equipment failure.
Be sure to prevent electrostatic damage due to discharge when working with this product for wiring, exchanging units,
setting up parameters, etc. by discharging static electricity on your body, etc.
Do not disassemble or detach during operation.
Do not push on any internal parts when wiring or removing and installing the globe.
To ensure proper safety while using the signal tower, observe the following:
Perform periodic pre-maintenance.
As a precaution against problems occurring, use this product together with other equipment.
Be sure to prevent electrostatic damage due to discharge when working with this product for wiring, exchanging
units, setting up parameters, etc. by discharging static electricity on your body, etc.
(To prevent damage from static electricity, touch hands or other body parts to metals or an earth ground to discharge
the body from static charge.)
Use a soft cloth moistened with water to clean the globe or case.
(Do not use thinner, benzine, gasoline or oil.)
To ensure safety when this product is installed onto equipment, observe the following:
Do not remove parts beyond those designed to be removed from this product.
Do not modify or disassemble this product.
Use only the specifi ed replacement parts listed in this document.
Safety Precautions
Caution
Warning
Caution
Notice
– 2 –
This icon indicates an action with the potential to
cause injury, physical loss or damage.
Hide quick links:
Advertisement
Table of Contents
