Table of Contents
Advertisement
5
Wiring
Make sure the power is OFF before wiring. A short circuit may damage internal circuits.
Ensure the proper working voltage is used. Any mistake in wiring may result in damage.
Do not pull the wire out or push it into the case.
Be sure the wiring is done properly. Any mistake in wiring may result in damage.
Be sure to put a fuse in the wiring circuit between the power source and equipment for protection.
If a fuse is not added, it may result in product and/or equipment failure.
NE-24A
TYPE
(1) Remove the globe by unscrewing it in a counter-
clockwise direction.
(2) Connect the wires to the screwless terminal block.
(3) Attach the globe by screwing it in a clockwise direction.
The terminals have no polarity.
(1) A minus driver etc. is used to pry the lever slot of the Terminal Block open, by
pushing straight onto the lever slot.
(2) The stripped side of the lead wire is inserted in the slot.
(3) The driver is removed to release the lever. (Check to make sure the lead wire
has been locked in place.)
Strip 8 mm of wire insulation from the wire to insert it in the Terminal Block.
The minus driver blade should be at about 2 mm by 0.5 mm in size.
Do not apply excess force to the screwless terminal block during wiring. Doing so may cause damage.
Make sure that there is no slack in the internal wiring.
Wiring hanging over the LED may cause a reduction in luminous intensity.
Caution
Screwless Terminal Block
Screwless Terminal Block wiring method
Caution
Notice
– 12 –
Applicable Wire Sizes
Single: 0.2 mm
Stranded: AWG 24 ~ 16
Wiring Example
2
2
~ 1.5 mm
Lever
Hide quick links:
Advertisement
Table of Contents
