Repair And Maintenance - Pulse Performance Products ATV QUAD Owner's Manual

Repair and Maintenance

WARNING:
Turn the power switch "OFF" before conducting any maintenance procedures.
Replacing the Chain
Tools required: 5mm hex wrench, 6mm hex wrench, 10mm wrench, Philips head screwdriver
1. Remove the rear right side axle bolt
hardware with a 6mm hex wrench.
4. Locate and remove the master link clip (A)
and slide out the master link from the chain.
Remove the entire chain.
7. Reinstall the axle thru bolt and tighten
securely with a 5mm hex wrench and 10mm
wrench.
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call (866) 434-6067.
2. Remove the thru axle bolt on the inside of
the wheel with a 5mm hex wrench and 10mm
wrench.
5. Install new chain around the gears and
reinstall the master link. Secure the link with
the master link clip (A).
8. Install the axle bolt hardware with a 6mm
hex wrench. Tighten securely.
3. Uncrew the 3 chain guard screws with a
Philips head screwdriver and remove the
chain guard cover.
6. Reinstall the chain cover and secure it using
the 3 screws and a Philips head screwdriver.
Do not overtighten the screws.
9