Repair And Maintenance - Pulse Performance Products ATV QUAD Owner's Manual

Repair and Maintenance

WARNING:
Turn the power switch "OFF" before conducting any maintenance procedures.
Adjusting the Brakes
Tools required: 10mm wrench
1. To adjust the brake cable, turn the
adjuster barrel on the brake lever clockwise
(loosen) or counter clockwise (tighten).
Only turn the barrel in small increments
until the desired adjustment is reached. If
brake continues to need further adjustment
proceed to the next step.
WARNING:
Always try to avoid skidding as this could cause you to lose control of the quad and will cause damage to
the rear tires. Practice using the brake in an unobstructed open area to become familiar with its function to make
smooth controlled stops.
8
Loosen
Tighten
2. If the brake cable is still either too tight or
too loose, use a 10mm wrench to loosen the
brake cable pinch bolt for further adjustment
on the cable. Ensure that the 10mm nut is
securely tightened after the adjustment is
made.
The brake could be capable of locking up and skidding the rear wheels if not applied correctly.
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call (866) 434-6067.
3. If the brake cable is adjusted correctly
but there is brake rub (brake contacts rotor
even when brake lever is not engaged) you
can adjust the centering of the brake caliper
on the rotor by turning the brake adjustment
knobs clockwise (away from wheel) or counter
clockwise (towards wheel). Rotate rear
wheels by hand while adjusting knob until
wheels spins freely.