Assembly - Pulse Performance Products ATV QUAD Owner's Manual

Assembly

Handlebar Assembly
Tools required: 5mm hex wrench, 10mm wrench
C
A
B
D
1. Align handlebars vertically and horizontally
onto clamps (A&B). Install the 4 clamp bolts
(C) and lock nuts (D) and hand tighten.
NOTE : The gap between the clamps (A&B) should be the same on both sides of the handlebar.
Tools required: Air/tire pump
air pressure maybe lost between the manufacture date and your
purchase date.
Using a hand pump with a Schrader-type valve and pressure gauge
not recommended to use pressurized system similar to the ones found
have much higher air capacity volumes.
REAR TIRE PSI: 30 MAX
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call (866) 434-6067.
E
F
2. Tighten bolts evenly and securely with a
5mm hex wrench (E) and 10mm wrench (F).
INFLATION
tires to the recommended PSI called out on the tires. Replace the
valve caps.
ENSURE ALL TIRES ARE AT THE CORRECT PSI
BEFORE RIDING THE QUAD.
3. Check to ensure handlebars are tight by
applying pressure before riding, handlebars
should not move backwards or forwards.
WARNING:
It is important to routinely check and maintain
tire pressure as this directly impacts the safety and performance
damage to the tires or the wheels.
5