To prevent fire or shock hazard,
do not expose the unit to rain or
To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified personnel
Mains lead must only be
changed at a qualified service
This appliance is classified as a
CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT
MARKING is located on the rear
The use of optical instruments with
this product will increase eye hazard.
As the laser beam used in this CD/
DVD player is harmful to eyes, do
not attempt to disassemble the
Refer servicing to qualified personnel
Notice for customers in the
United Kingdom and Republic
A moulded plug complying with
BS1363 is fitted to this equipment for
your safety and convenience.
Should the fuse in the plug supplied
need to be replaced, a 5 AMP fuse
approved by ASTA or BSI to
BS1362, (i.e., marked with
mark) must be used.
If the plug supplied with this
equipment has a detachable fuse
cover, be sure to attach the fuse cover
after you change the fuse. Never use
the plug without the fuse cover. If
you should lose the fuse cover, please
contact your nearest Sony service
• This unit operates on 220 – 240 V
AC, 50/60 Hz. Check that the unit's
operating voltage is identical with
your local power supply.
• If anything falls into the cabinet,
unplug the unit and have it checked
by qualified personnel before
operating it any further.
• The unit is not disconnected from
the mains as long as it is connected
to the mains outlet, even if the unit
itself has been turned off.
• Unplug the unit from the wall outlet
if you do not intend to use it for an
extended period of time. To
disconnect the cord, pull it out by
the plug, never by the cord.
• Allow adequate air circulation to
prevent internal heat buildup.
• Do not place the unit on surfaces
(rugs, blankets, etc.) or near
materials (curtains, draperies) that
may block the ventilation slots.
• Do not install the unit near heat
sources such as radiators, or air
ducts, or in a place subject to direct
sunlight, excessive dust,
mechanical vibration, or shock.
• Do not install the unit in an inclined
position. It is designed to be
operated in a horizontal position
• Keep the unit and discs away from
equipment with strong magnets,
such as microwave ovens, or large
• Do not place heavy objects on the
• If the unit is brought directly from a
cold to a warm location, moisture
may condense inside the CD/DVD
player and cause damage to the
lenses. When you first install the
unit, or when you move it from a
cold to a warm location, wait for
about 30 minutes before operating
Thank you for purchasing this Sony
CD/DVD Player. Before operating
this player, please read this manual
thoroughly and retain it for future