Table of Contents
Advertisement
2. How to add, change or delete access
codes on your Qolsys panel
2.1 Add a user via the Qolsys IQ Panel 2
1.
Press or swipe down the clock display at the top to open the settings tray then press Settings.
2.
Press Advanced Settings then enter the master code; this is the default code you selected when the IQ Panel 2 was installed.
3.
Press User Management then press the Add User button.
4.
Press Name, enter a name (up to 10 characters) then press the bottom-right keyboard icon.
5.
Press User Code, enter a user code then press the > button.
6.
Enter the user code again to confirm then press the > button.
7.
Under User Type, specify if this user can make changes to your alarm system.
•
Select Master if you want this user to be able to make changes.
•
Select Guest if you only want this user to arm and disarm your alarm system.
8.
Press Add User to finish then press the back arrow or Home to exit.
2.2 Remove a user via the Qolsys IQ Panel 2
1.
Press or swipe down the clock display at the top to open the settings tray then press Settings.
2.
Press Advanced Settings then enter the master code.
3.
Press User Management then press the trash icon by the user to delete.
4.
Press OK to confirm then press the back arrow or Home to exit.
5 ‒ How to use my Qolsys Security and Automation panel
Advertisement
Table of Contents
