Section 1.0 Introduction; Purpose, Scope, And Audience; Section 2.0 System Specifications; Hardware Description - Ideal Power Stabiliti Series Quick Start Manual

0

SECTION 1.0 INTRODUCTION

Purpose, Scope, and Audience

This Quick Start Guide describes the features and capabilities of the Stabiliti™ 30C3 Multiport
Power Conversion System ("PCS" or "Converter"), as well as the Stabiliti™ 30C Dual Port PCS.
It should be used in conjunction with other product documentation provided by Ideal Power
("IPWR"), which are referenced throughout this Quick Start Guide.
The intended audience is engineering lab personnel familiar with high-voltage/high-power
systems and the general safety issues related to the wiring and use of 3-phase AC power and
high-voltage battery and PV systems.
The Stabiliti™ Series Installation and Operations Manual (MAN-00115) should be used to
ensure safe installation and operation of this Converter. Please review this entire document
prior to starting your system evaluation. Contact
as needed.

SECTION 2.0 SYSTEM SPECIFICATIONS

Hardware Description

The 30C3 PCS uses IPWR's proprietary Power Packet Switching Architecture™ ("PPSA") to
efficiently transfer and manage power flows amoung three power ports: AC1, DC2, and DC3:
 AC1 is a 3-Wire, 3-Phase AC power port.
 DC2 is a DC power port typically dedicated to battery-based energy storage systems.
 DC3 is an auxiliary DC power port for use with a second battery system, or a PV Array.
The 30C is a Dual Port PCS based on the 30C3 platform. The primary difference is that the Port
DC3 power electronics are depopulated and disabled at the factory. Other than the noted
depopulation of power electronics on DC3, the Stabiliti™ Series PCS share a common
Firmware and Hardware platform.
The 30C has the following power port configuration:
 AC1 is a 3-Wire, 3-Phase AC power port.
 DC2 is a DC power port typically dedicated to battery-based energy storage systems.
The remainder of this document is dedicated to the 30C3, which can be configured to emulate
the 30C by setting port DC3 to the IDLE Control Method.
Quick Start Guide Stabiliti™ Series PCS
MAN-00114, Rev D
support@idealpower.com for technical support
Page 5 of 28