Section 4.0 High-Voltage Wiring; Wiring Access; Ac1 Interconnect Board; Figure 2: 30C3 Ac1 Wiring Interconnection Board - Ideal Power Stabiliti Series Quick Start Manual

NOTE: Not for customer use.

SECTION 4.0 HIGH-VOLTAGE WIRING

Before connecting AC and DC power sources, it is recommended that the user first operate the
PCS with only the Aux 24 Vdc power supply connected. Doing so enables access to the Control
Board and the various configuration, control, and monitoring features supported by the
Stabiliti™ Series PCS and detailed later in this document.

Wiring Access

IPWR recommends that all product evaluations begin with a low-voltage systems analysis first
as described in the paragraph above. Once the systems analysis is completed, connect AC and
DC power sources. The Converter wiring compartments are accessed by eight hex screws
which open the full-sized (20.5" x 40") hinged front door.
 High-voltage AC1 connection points are located on the left bottom section of the
Converter enclosure.
 High-voltage DC2 and DC3 connections are located on the right bottom section of the
Converter's enclosure.
NOTE: Do not disturb or change the factory wiring connections, which are made to the top of
the AC1 Interconnect Board, and the DC2/DC3 Interconnect Board shown below..

AC1 Interconnect Board

Quick Start Guide Stabiliti™ Series PCS
MAN-00114, Rev D
Figure 2: 30C3 AC1 Wiring Interconnect Board
Page 11 of 28