Adjustment Of The Clutch/Brake, Hst; Adjustment Of The Clutch, Man - Stiga VILLA 2000 Workshop Manual

Edition Manual
2008-05-19 Workshop Manual, Stiga Villa/Ready 5 Belts
5.4.2 Adjustment of the clutch/brake,
HST
Adjust the nuts (N1 + N2) at the clutch/brake
lever to a play of 3 mm between the lock pin
and the clutch lever.
After the adjustment, tighten the nuts (N1 +
N2).

5.4.3 Adjustment of the clutch, Man

Note!
Manual machines shall have 0 mm play
at the clutch rod (Q).
If the clutch not disengage the engine rotation
properly, it will be very difficult to change gears.
In that case, adjust the clutch as follows:
1. Hold the clutch rod (Q) with a polygrip and
loosen the rear nut (O2) until the clutch rod
(Q) is completely loose. Now, the belt
stretching will perform the stop for the clutch
arm (P). I.e the belt is max stretched by the
spring.
2. Screw the rear nut (O2) slowly forward until
the clutch arm (P) begin to move. Then
screw the nut one more turn. If nessecary,
move the front nut (O1) forwards.
3. Lock by screwing the forward nut (O1)
backwards and tighten against the lever
loop. Hold the clutch rod (Q) with a polygrip
when tightening the nut.
Chapter
N1 N2
O1 O2
Page
10
3 mm
Q
P
0 mm