Advertisement
1) Operation instruction:
Press PROD button to enter into "FACTORY" mode. Press and hold VOL-
button on remote control unit till the volume decreases to "0", and meanwhile
press POS- button on the remote control unit to open factory flag setting up
menu.
The setting up menu consists of two screens used to adjust line 1 and line 2
respectively. After the setting up menu is open, press POS+/POS- button to
select different options. If display item is selected, a yellow bar will point out
the adjustable characters. If other options are selected, the OSD display will
become red. Otherwise, the display is in green. If an option to be set is
selected, press VOL+/VOL- button to set up different values.
Adjusting of display content use POS+/POS- button to select the adjusting
options on line1 or line 2. A yellow bar will point out the adjustable characters.
Use VOL+/VOL- button to adjust the content of characters indicated by the
yellow bar. Press PP button to select other characters on the same line.
The OSD of setting menu will keep on displaying. After setting is finished, press
DISPLAY to quit.
The setting of factory logo is "Seeing is attaining", that is, the content, color, size
and position displayed in the content line are the same as in normal display
except that
quitting. The effect attainable after adjustment can be seen objectively in the
course adjustment.
The setting of the two lines of display content should not overlap (even if one
line is set to "OFF") to avoid abnormal phenomena.
2) OSD display
represents the normal factory flag display is blank after
Advertisement
