Advertisement
When in WOOF OSD, and WOOFER ON status, if "WOOF VOL.OPT" is set
to "1" WOOF VOLUME will appear. Use VOL+ and VOL- to change the
woofer output volume.
If woofer function is not selected, then just cancel the relevant button on the
remote control unit.
Output mode
There are two output modes, output through TA1216AN and CPU
respectively
3) OSD display (about 5 seconds)
WOOF
WOOF VOLUME
4-10 MENU local button
1) Function enter into PICTURE, AUDIO, SYSTEM, CLOCK, PRESET and
CHANNEL menu.
2) Description
Press MENU button to change as follows
PICTURE menu
none
PRESET menu operation instruction:
When OSD display is neither one of those of PICTURE, AUDIO, SYSTEM,
CLOCK, PRESET or CHANNEL menu press MENU button the OSD of
PICTURE menu will display first.
In AV mode, neither PRESET nor CHANNEL menu will turn up in the cycle
when MENU button is pressed.
If stereo control function is not selected, AUDIO menu will not appear in the
cycle.
3) PRESET menu operation instruction
After finding the PRESET menu press POS /POS- to select. The options
with an arrow are currently selected ones. The other options are in green.
Press VOL
fine adjustment and semi-auto search, press VOL
please refer to descriptions in "2-3" section.
ON
WOOF button
50
AUDIO menu
CHANNEL menu
and VOL
buttons to change setting values and to start. During
WOOF
OFF
SYSTEM menu
PRESET menu
CLOCK menu
to move upward and
Advertisement
